Pew bows for church decorations

To decorate the entire church for the wedding is not the easiest of tasks. I was doing some search for ideas on how to decorate the church and found that simple pew bows can do wonders and they give the church a nice, weddingy look. Of all the pew bow designs I've looked through, I like the above one the best.

Hopefully the home-made pew bows will turn out as classic as the ones in the picture, if not better.

Found some instructions on how to make them.

MATERIALS FOR ONE BOW

4 1/2 yds (4.5m) of
2 5/8-inch wide (6.5cm) brocade merrow-edge wire ribbon in ivory
4 1/2 yds (4.5m) of
1 1/2-inch-wide (4cm) wire-edge sheer ribbon in ivory
1 yd (1m) of 2 5/8-inch wide (6.5cm) wire-edge sheer ribbon in ivory.
2 to 3 branches of ivy
Tacky glue or hot glue

DIRECTIONS

Cut three 1 1/2-yard (1.5m) lengths from the 2 5/8-inch (6.5cm) ivory brocade ribbon. With right sides out, make a 6-inch (15cm) loop at one end of each. Wire all three lengths together and notch ends.

Following the instructions below, make a twelve-loop bow with 16-inch (40.5cm) tails from the 1 1/2-inch (4cm) ivory sheer ribbon. Wire this bow to the loops from step 1.

Following the instructions below, make a fancy pulled rose from the 2 5/8-inch (6.5cm) ivory sheer ribbon. Glue the rose to the center of the ribbon bow.

Glue the ivy to the pew bow.

GENERAL BOW TECHNIQUES

To fasten a bow with wire, fold an 18-inch (50cm) length of wire in half. Place the folded wire underneath the chosen ribbon and wrap the wire around the center, inserting the wire ends through the loop to tighten. Pull the wire ends to secure, bringing one end around center again at back. To tighten, twist the bow -- not the wire -- a few times.

TWO-LOOP BOW AND VARIATIONS

Cut a length of ribbon as specified in the project instructions. Wrap the ribbon back and forth, forming two loops with tails. Glue a small strip of ribbon around the ribbon loops to hold it in place. Ease the ribbon tail to the back of the bow.

For four-, six-, eight-, ten-, and twelve-loop bows, simply increase the number of loops before securing the center strip.

Note: When using ombre~ ribbon, results will differ depending on which side of the ribbon you work. Experiment with this for interesting color variations.

PULLED OR GATHERED ROSE

Cut ribbon to desired length. Knot one end, and pull knot firmly toward end to secure. From opposite side, gently pull one wire, slowly gathering ribbon along that edge. Continue gathering until entire side is completely ruffled and curling naturally. Wrap gathered ribbon around knotted end, forming a bud. Continue wrapping lightly so ribbon flares out and acquires an open rose effect. Tie wires together and trim. Adjust shape by fluffing or crumpling.

Author's note: This content is courtesy of Offray.com